Rotax 912 i Series Maintenance Manual page 125

MAINTENANCE
As well as the maintenance and special checks,
see the relevant Maintenance Manual Line for
the respective 912 i Series engine type.
REMOVAL
POWER PLANT - REMOVAL
Preparation
To remove the engine, carry out the following
steps. If these steps are included and listed in
the instructions of the aircraft manufacturer (see
"Documentation of the aircraft manufacturer"),
then the steps given here should be treated as
additional information.
- Secure the aircraft appropriately
- Switch the ignition key OFF
- Disconnect the battery
- Switch the tank selector switch OFF
- Remove cowling
- Disconnect fuel lines
- Drain the residual fuel out of the lines and
seal the lines
- Drain the coolant
- Drain the oil
DISCONNECTING THE LINES TO THE
AIRCRAFT
Disconnect all the extension lines between the
engine and the aircraft.
Step
1 Remove the spinner and propeller (see
section 61-00-00).
Starter relay:
See Fig. 4.
Step
1 Loosen M6 hex. nut and remove it along
with the 6.4 washer. Pull off faston con-
nector. Press the lock to pull off the faston
connector.
2 Loosen the earthing Allen screw.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Fig. 4
1. Starter relay
3. 6.4 washer
5. Earthing
Ambient pressure sensor:
.
See Fig. 5
Step
1 Push in the tab on the top of the connector
and at the same time pull the connector
out of the connection socket.
Fig. 5
1. Tab
2. M6 hex. nut
4. Faston connector
6. Allen screw
Procedure
2. Connection socket
71-00-00
Page 15
July 01/2012