Rotax 912 i Series Maintenance Manual page 383

CRANKSHAFT POSITION SENSOR ASSY.
(CPS_1, CPS_2) - REMOVAL
Installation position: Ignition housing
Step
1 Unplug the respective connector of the
wiring harness (main strand) from the cor-
responding crankshaft position sensor as-
sy. See also section 76-50-00 Wiring har-
ness (main strand).
2 Lift the latch and pull apart.
3 Pull the connector out of the support
plate.
Fig. 16
1. Connector CPS_1
3. Support plate
Step
4 Loosen the M6x20 Allen screw and wash-
er with an Allen key 5 (or similar tool) and
remove the cable clamp.
5 Remove crankshaft position sensor assy.
6 Close the bore with the appropriate pro-
tective covering.
NOTICE
WARNUNG
Ensure that the O-ring is positioned on the
crankshaft position sensor assy.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Connector CPS_2
Procedure
Fig. 17
1. Crankshaft position
sensor CPS_1
3. Cable clamp
5. M6x20 allen screw
THROTTLE POTENTIOMETER (TPS) -
REMOVAL
Installation position: Throttle body
The throttle potentiometer is not availab-
NOTE:
le as a spare part.
Step
1 Unplug the respective connector of the
wiring harness from the throttle potenti-
ometer. See also section 76-50-00 Wiring
harness (main strand).
2 Remove the throttle body assy. To do this,
see section 73-10-00 Fuel pump and dis-
tribution.
2. Crankshaft position
sensor CPS_2
4. Washer
Procedure
76-70-00
Page 13
July 01/2012