Rotax 912 i Series Maintenance Manual page 309

FINISHING WORK
- Put the 2 cable ties on the knock sensor line.
See also section 76-50-00 Wiring harness.
- Install the double ignition coils and resistance
spark plug connectors. See also section 74-
20-00 Ignition unit.
- Install the air filter with the heat shield. See
the current Maintenance Manual Line.
- Fill with coolant. See relevant Maintenance
Manual Line for the 912 i Series engine type.
- Bleed the engine cooling system. See rele-
vant Maintenance Manual Line for the 912 i
Series engine type.
- Fill with fuel. See relevant Maintenance
Manual Line for the 912 i Series engine type.
- Carry out an engine test run. See relevant
Maintenance Manual Line for the 912 i Series
engine type.
- Install the fuel line assy. See also section 73-
10-00 Fuel system.
- Install the 1-ear clamps.
- Install the cable ties for the fuel pressure
regulator. See also section 73-10-00 Fuel
system.
- Install the wiring harness.
See also section 76-50-00 Wiring harness.
- Install the fuel hose inlet and return line. See
also section 73-10-00 Fuel system.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
75-00-00
Page 21
July 01/2012