Rotax 912 i Series Maintenance Manual page 379

Fig. 4
1. Pressure sensor
Step
4 Loosen the pressure sensor with an SW
19 open-ended spanner part no. 876130
(or a similar tool) and remove it.
5 Close the threaded bore with the appro-
priate protective covering.
PRESSURE/TEMPERATURE SENSOR
(AAPTS) - REMOVAL
Installation position: Aircraft frame
Step
1 Push in the tab on the top of the connector
and at the same time pull the connector
out of the connection socket.
2 Follow the aircraft manufacturer's instruc-
tions for disassembly.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. Cable ties
Procedure
Procedure
Fig. 5
1. Pressure/temperature sensor
TEMPERATURE SENSOR
(MATS_1+MATS_2) - REMOVAL
Installation position: Airbox
Step
1 Cut open the cable ties.
2 Unplug the relevant connector of the wir-
ing harness from the corresponding tem-
perature sensor (MATS). See also sec-
tion 76-50-00 Wiring harness (main
strand).
Fig. 6
1. Temperature sensor
2. Connection socket
.
Procedure
Cable ties
76-70-00
Page 9
July 01/2012