Rotax 912 i Series Maintenance Manual page 357

Step
2 Unplug the connectors (FUEL PUMP 1,
FUEL PUMP 2) from the fuel pumps.
NOTE: First lift one side with a screwdri-
ver, fix the tab and then lift the
lower tab with the screwdriver
and pull out the connector.
NOTICE
WARNUNG
Do not pull on the cable!
Fig. 9
1. Fuel pump (main)
3. Connector (fuel pump 1) 4. Connector (fuel pump 2)
Fig. 10
1. Connector (fuel pump 1)
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Fuel pump (auxiliary)
2. Screwdriver
CONTROL UNIT (ECU) - DISCONNEC-
TION
See also section 76-10-00 Control unit.
Wiring harness designation:
- ECU LANE A1
- ECU LANE A2
- ECU LANE B
Step
1 Unplug the couplers (ECU LANE A1, ECU
LANE A2 and ECU LANE B).
Fig. 11
1. Coupler (LANE A1)
2. Coupler (LANE A2)
3. Coupler (LANE B)
Step
2 Press in the lock so that the clamp can be
rotated.
3 Press the clamp down until it latches.
4 Remove the coupler.
Procedure
Procedure
76-50-00
Page 9
July 01/2012