Rotax 912 i Series Maintenance Manual page 429

INSTALLATION
OIL PUMP - INSTALLATION
Preparation
- Check the fit of the o-rings on the oil pump
housing .
NOTICE
WARNUNG
Ensure that the oil pump shaft is in the correct
installation position.
Fig. 22
1. Oil pump shaft
3. O-rings
Step
1 Apply LOCTITE 5910 to the support area
on the crankcase.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. Oil pump housing
Procedure
Fig. 23
1. Crankcase
Step
2 Install the oil pump housing with M6x50
Allen screws and 6.4 washers crosswise
and by hand. Then tighten the Allen sc-
rews crosswise.
Tightening torque 10 Nm (88.48 in. lb.).
3 Tighten plug screw.
Tightening torque 30 Nm (265.44 in. lb.).
4 Attach the safety wire.
Fig. 24
1. M6x50 Allen screws
3. M22x1.5 plug screw
Procedure
2. 6.4 washers
4. Oil filter
79-00-00
Page 17
July 01/2012