Step
2
Position the vacuum pump including the
gasket and the attachment flange on the
crankcase.
3
Screw 4 M6 hex. nuts including lock
washers onto M6 studs and tighten them.
Tightening torque 25 Nm (18.44 ft.lb.)
Fig. 13
1. Vacuum pump
2. Gasket
Fig. 14
1. Vacuum pump
3. M6 hex. nut
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
3. Attachment flange
4. M6 stud
2. 6.4 lock washer
FINISHING WORK
- Install the propeller gearbox, see section 72-
10-00.
37-10-00
Page 9
July 01/2012