Rotax 912 i Series Maintenance Manual page 106

Fig. 15
1. M5x12 countersunk
screw
ROLLER BEARING - INSTALLATION
Step
1 Lubricate a new O-ring and push it into
the crankcase with the oil inlet flange.
Ensure that the two M6 threads are
NOTE:
horizontal and the recess is suitable
for the scavenge oil.
Step
2 Install the governor flange with two M6x20
Allen screws and the oil inlet flange with
two M6x16 Allen screws lightly at first for
better positioning.
Fig. 16
1. Oil inlet flange
3. M6 threaded bores
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. Retaining washer
Procedure
Procedure
2. O-ring
Fig. 17
1. Governor flange
3. M6x16 Allen screws
Step
3 Install the extractor part no. 877615 onto
the crankcase, place the press-in mush-
room part no. 877590 in the roller bearing,
put it on the centring and press it with the
spindle into the crankcase as far as it will
go.
NOTE: Place the circlip in the groove with
the sharp edge pointing out-
wards.
Fig. 18
1. Extractor part no. 877615
3. Roller bearing
2. M6x20 Allen screws
Procedure
2. Press-in mushroom
part no. 877590
61-20-00
Page 12
July 01/2012