Rotax 912 i Series Maintenance Manual page 69

The through-bore of the screw pene-
NOTE:
trates as far as the crankcase.
The engine is not leakproof if this screw
is not glued.
Fig. 40
1. M6x50 hex. screw
3. Cable clamp
NOTICE
WARNUNG
If the water pump is not installed straight away,
then 2 M6x65 auxiliary screws with washers
must be screwed in so that the sealing surface
is evenly clamped.
Fig. 41
1. M6x65 Allen screw
Step
8 Fasten M5x45 hex. screws for the starter.
Tightening torque 6 Nm (53 in. lb.)
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
2. Washer A 6.4
2. Water pump wheel
Procedure
No washers are used for these screws,
NOTE:
as otherwise the starter does not lie flat
on the flange surface.
See Fig. 42.
Fig. 42
1. M5x45 hex. screw
FINISHING WORK
- Install water pump housing with a new seal.
See also section 75-00-00 Cooling system.
- Install electric starter.
See also section 80-00-00 Electric starter.
- Install pressure sensor. See
section 76-70-00 Sensors and actuators.
- Install airbox on ignition housing. See also
section 73-10-00 Fuel system.
- Release crankshaft. See relevant Main-
tenance Manual Line for the 912 i Series
engine type.
2. M5 hex. collar nut
24-20-00
Page 19
October 01/2013