Rotax 912 i Series Maintenance Manual page 370

CONTROL UNIT (ECU) - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
FUEL PUMP - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
FUSE BOX (FUSE BOX) - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
AMBIENT PRESSURE SENSOR -
CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
STARTER RELAY - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
FINISHING WORK
- Check that all plug connections are secure,
contacted and free from corrosion and dirt.
- Check the grounding for good contact and
cleanliness.
- Carry out an engine test run. See section 12-
20-00 in the corresponding Line Maintenance
Manual for the 912 i Series engine type.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
76-50-00
Page 22
July 01/2012