Rotax 912 i Series Maintenance Manual page 361

Fig. 22
1. M5x12 Allen screw
3. Heat shield
Step
6 Disconnect the injectors.
NOTE: The cables are labelled INJ_1 to
INJ_8.
Fig. 23
1. Injector connectors
Step
7 Use a screwdriver to lever out the spring
clip and then
unplug the connector.
NOTE: Let the wire clip snap back in af-
ter the connector has been dis-
connected so that it does not get
lost.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. 5.3 washer
4. M5x35 Allen screw
Procedure
Procedure
Fig. 24
1. Injector
THROTTLE POTENTIOMETER (TPS) -
DISCONNECTION
NOTICE
WARNUNG
Do not damage the wiring harness. Always cut
open on the side of the support plate facing
away from the wiring harness.
Step
1 Cut open the 2 cable ties on the airbox.
2 Unplug the throttle potentiometer.
- Lift the latches.
- Unplug the connector.
2. Screwdriver
Procedure
76-50-00
Page 13
July 01/2012