Rotax 912 i Series Maintenance Manual page 109

GOVERNOR INSTALLATION
Various screws and nuts are required, depen-
ding on the manufacturer of the governor. See
the current edition of SB-912-052 "Installation/
use of governors".
Governors manufactured by
NOTE:
McCAULEY and WOODWARD can-
not be installed in the 912 i Series
engine type due to their length.
NOTICE
WARNUNG
The gear-tooth system of the governor must
mesh when installed!
The governor is installed in the same way as it is
removed. See Chapter 61-20-00
FINISHING WORK
- Install the propeller gearbox, see section
72-10-00.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
61-20-00
Page 15
July 01/2012