Rotax 912 i Series Maintenance Manual page 437

REMOVAL
TEMPERATURE SENSOR (OIL) -
REMOVAL
Step
1 To do this, see section 76-70-00 Sensors
and actuators.
2 Clean the thread of the oil temperature
sensor.
INSPECTION
TEMPERATURE SENSOR (OIL) -
INSPECTION
Step
1 To do this, see section 76-70-00 Sensors
and actuators.
INSTALLATION
TEMPERATURE SENSOR (OIL) -
INSTALLATION
Step
1 To do this, see section 76-70-00 Sensors
and actuators.
PRESSURE SENSOR (OIL)
General note
The pressure sensor for measuring the oil pres-
sure is screwed into the ignition housing.
The pressure sensor has a range from 0
NOTE:
to 10 bar. This indicator can be seen on
the circumference of the pressure sen-
sor.
NOTICE
WARNUNG
The pressure range of the display device must
match the pressure range of the pressure sen-
sor. Otherwise the oil pressure will not be dis-
played correctly.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Procedure
NOTICE
WARNUNG
The temperature must be no more or less than
the max. operating temperature.
z
REMOVAL
PRESSURE SENSOR (OIL) -
REMOVAL
Step
1 To do this, see section 76-70-00 Sensors
and actuators.
2 Clean the thread of the pressure sensor.
INSPECTION
PRESSURE SENSOR (OIL) -
INSPECTION
Step
1 To do this, see section 76-70-00 Sensors
and actuators.
INSTALLATION
PRESSURE SENSOR (OIL) -
INSTALLATION
Step
1 To do this, see section 76-70-00 Sensors
and actuators.
Procedure
Procedure
Procedure
79-00-00
Page 25
July 01/2012