Rotax 912 i Series Maintenance Manual page 378

Fig. 1
ECU
LANE A
LANE B
Wiring diagram – elimination process
PRESSURE SENSOR (MAPS_1/MAPS_2) -
REMOVAL
Installation position: Airbox
Step
1 Cut open the cable ties.
Fig. 2
1. Pressure sensors
Step
2 Pull the respective connector of the wiring
harness out of the corresponding pres-
sure sensor (MAPS_1/MAPS_2). See
also section 76-50-00 Wiring harness
(main strand).
3 Lift the latch and pull off.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Sensor LANE A
Sensor LANE B
06341
Procedure
2. Cable ties
Procedure
Step
4 Loosen the pressure sensor with an SW
21 open-ended spanner (or a similar tool)
and remove it.
5 Close the threaded bore with the appro-
priate protective covering.
Fig. 3
1. Pressure sensor
PRESSURE SENSOR (OPS) - REMOVAL
Installation position: Ignition housing
Step
1 Cut open the cable ties on the pressure
sensor.
2 Pull the respective connector of the wiring
harness out of the corresponding pres-
sure sensor (OPS). See also section 76-
50-00 Wiring harness (main strand).
3 Lift the latch and pull out the connector.
Procedure
Procedure
76-70-00
Page 8
July 01/2012