Rotax 912 i Series Maintenance Manual page 433

Fig. 28
INSTALLATION
OIL TANK - INSTALLATION
Preparation
- Install the oil tank according to the aircraft
manufacturer's specifications.
FINISHING WORK
- Fill with fresh oil.
See relevant Maintenance Manual Line for
the 912 i Series.
- Bleed the oil system.
See relevant Maintenance Manual Line for
the 912 i Series.
- Carry out an engine test run and leakage
check.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
REMOVAL
REMOVAL OF THE OIL COOLER
WARNUNG
The oil cooler is not included in the delivery of
the engine. Maintenance must be carried out in
accordance with the aircraft manufacturer's
instructions.
WARNUNG WARNING
Danger of severe burns and scalds! Always
allow the engine to cool down to ambient tem-
perature before starting any work.
Preparation
- Switch the ignition key OFF
- Drain the oil
ENVIRONMENT NOTE
Dispose of used oil according to local environ-
mental regulations.
WARNUNG
Use appropriate protective coverings to prevent
the ingress of debris particles into all discon-
nected lines and connections.
- Remove surrounding assemblies and detach
oil lines.
The assemblies and lines are only to be
NOTE:
removed if necessary and only as far as
is necessary!
Step
1
ENVIRONMENT NOTE
Ensure that no oil gets into the waste water sys-
tem or the ground – risk of contaminating drin-
king water!
NOTICE
NOTICE
Procedure
Remove the oil lines and clamps
according to the instructions in the aircraft
manufacturer's manual.
79-00-00
Page 21
July 01/2012