Rotax 912 i Series Maintenance Manual page 329

Fig. 20
B.U.D.S. Aircraft "Maintenance Mode" (connect)
NOTICE
WARNUNG
If connection status lamps would not turn to
GREEN, try turning the LANES to "OFF" and
then to "ON" again.
Step
10 When both connection state indicators
become "GREEN", change to "Logs" Tab.
11 Click on "Extract Logs". A settings window
named "ECU Log Extraction" should
open.
Fig. 21
„B.U.D.S. Aircraft „Maintenance Mode" : Logs
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
09963
Procedure
09964
Step
12 In this window ("ECU Log Extraction")
choose respective LANE A and LANE B
for Log-extraction (field:"ECU LANE Se-
lection").
NOTE: If only one LANE has been con-
nected or the user wants to ex-
tract the logs from one LANE,
the corresponding option must
be selected here.
13 In the field"ECU Log Selection" the type of
extracting Logs must be chosen.
Choose "Fault and Data logs".
Faultlogs: Fault/Failure/Warning en-
NOTE:
tries in the ECU.
Datalogs: ECU information stored in
a circular buffer.
Step
14 Furthermore select ECU Log Extraction
Directory.
NOTICE: The User must have writing per-
mission for this folder.
15 Press "OK" subsequently. The extraction
process will start.
Fig. 22
B.U.D.S. Aircraft settings for Log-extraction
NOTICE
WARNUNG
Extraction process could take several minutes
depending on the number of logs.
Procedure
Procedure
09965
76-10-00
Page 17
October 01/2013