Rotax 912 i Series Maintenance Manual page 434

INSPECTION
OIL COOLER - INSPECTION
NOTICE
WARNUNG
The oil cooler is not included in the delivery of
the engine. Maintenance must be carried out in
accordance with the aircraft manufacturer's
instructions.
Preparation
- Clean all parts carefully. See also section 05-
00-00 Procedures
- General visual inspection. See relevant Main-
tenance Manual Line for the 912 i Series
engine type.
Step
1 Clean the cooling fins of the oil cooler and
straighten them out if necessary.
2 Rinse out the inside of the oil cooler.
NOTICE
WARNUNG
If the engine is damaged so that chips can be
found in the oil filter and on the magnetic plug,
the oil cooler must be replaced.
INSTALLATION
OIL COOLER - INSTALLATION
Step
1 Install the oil lines and clamps according
to the instructions in the aircraft manu-
facturer's manual.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
FINISHING WORK
- Fill with fresh oil.
See relevant Maintenance Manual Line for
the 912 i Series.
- Bleed the oil system.
See relevant Maintenance Manual Line for
the 912 i Series.
- Carry out an engine test run and leakage
check.
79-00-00
Page 22
July 01/2012