REMOVAL OF THE DEEP GROOVE BALL
BEARING
After the propeller gearbox has been removed,
the propeller shaft bearing on the crankcase side
and the oil seal must be replaced.
NOTICE
WARNUNG
The shaft seal is damaged in the process and
must therefore be replaced.
Step
1
Loosen 4 M7x16 hex. screws with wash-
ers from the gearbox housing.
2
Heat the gearbox housing about 100 to
120 °C and press the deep groove ball
bearing together with the oil seal and radi-
us ring inwards with a suitable insertion
jig.
Fig. 9
1. M7x16 hex. screw
3. Ball bearing 6207 E
THNC3
5. Oil seal AS 40x55x7 FPM
REMOVAL OF THE ROLLER BEARING,
VERSION 3
See also section 61-20-00 Governor.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. 7.2/18.8/3 washer
4. 36/50/5.5 radius ring
72-10-00
Page 9
July 01/2012