Rotax 912 i Series Maintenance Manual page 435

REMOVAL
REMOVAL OF THE OIL LINE
NOTICE
WARNUNG
The oil lines are not included in the delivery of
the engine and must be maintained according to
the aircraft manufacturer's instructions.
Step
1 Remove the oil lines and clamps
according to the instructions in the aircraft
manufacturer's manual.
REMOVAL OF THE OIL LINE (STEEL LINE)
NOTICE
WARNUNG
The steel oil lines, which are included in the deli-
very, are only removed if they are damaged or
for cleaning.
Step
1 Remove the cable clamp for supporting
the line on the side of the gearbox.
2 Loosen the M10 banjo bolt and gasket
ring on the governor flange. See also sec-
tion 61-20-00 Governor.
3 Loosen the banjo bolt on the oil pump
housing and remove it along with the gas-
ket rings. See also section 61-20-00 Go-
vernor.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Fig. 29
1. Oil line
3. M10 banjo bolt
INSPECTION
OIL LINE - INSPECTION
Preparation
- Clean all parts carefully. See also section 05-
00-00 Procedures
- General visual inspection. See relevant Main-
tenance Manual Line for the 912 i Series
engine type.
2. Cable clamp
79-00-00
Page 23
July 01/2012