Rotax 912 i Series Maintenance Manual page 257

CHECK VALVE - INSPECTION
See Fig. 47.
Step
1 Check the check valves for damage and
wear.
LINE AND HOSE - INSPECTION
See Fig. 47
Step
1 Check the lines and hoses for damage
and wear.
AIR FILTER - INSPECTION
Step
1 Check the air filter according to the air-
craft manufacturer's instructions.
See the most recent Line Maintenance
Manual, section 12-20-00.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Procedure
ASSEMBLY
FUEL PUMP ASSY. - ASSEMBLY
Step
1 Fix the fuel pump unit in the housing with
4 M6 hex. nuts.
Tightening torque 10 Nm (88.48 in. lb.)
Fig. 48
1. M6 hex. nut
3. Fuel pump unit
Step
2 Connect the wiring harness connector ap-
propriately. See also section 76-50-00
Wiring harness.
3 Fix the cover with 4 Allen screws. Tighten-
ing torque 6 Nm (53.09 in. lb.)
4 Install the fuel line assy.
NOTE: The position and type of positioning and
attachment of the fuel pump depends on
the aircraft type. See aircraft manufactu-
rer documentation.
Procedure
2. Housing
Procedure
73-10-00
Page 25
July 01/2012