Rotax 912 i Series Maintenance Manual page 295

Fig. 2(Cyl. 1/3):
8. Throttle potentiometer TPS
10. Double ignition coil
12. Fuel hose assy.
EXPANSION TANK AND COOLANT HOSE
(PREFORMED HOSE) - REMOVAL
NOTICE
WARNUNG
Mark the position of the spring type hose clips.
The spring type hose clips must be re-installed
in the same position, otherwise it may not be
possible to install the intake manifold. Risk of
pressure and scuffing marks!
NOTICE
WARNUNG
When removing the preformed hoses, ensure
that the coolant elbows are not damaged!
Step
1 Take off the spring type hose clip using
spring clamp pliers part no. 877840.
2 Remove the preformed hose from the
coolant elbow with a suitable tool.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
9. Oil filter
11. Fuel inlet
Procedure
Preformed hose, cylinders 2 and 4
Fig. 3
1. Spring type hose clip
3. Coolant elbow
Preformed hose, cylinder 1
Fig. 4
1. Spring type hose clip
3. Coolant elbow
2. Preformed hose
2. Preformed hose
75-00-00
Page 7
July 01/2012