Rotax 912 i Series Maintenance Manual page 131

Step
4 Install the screw connections of the
engine suspension to the fire wall
according to the aircraft manufacturer's
instructions and tighten them diagonally
from each other.
5 Reduce the tension of the installation po-
sition of the engine by lowering it slightly
and tighten the four screw connections
likewise diagonally from each other
according to the tightening torque values
of the aircraft manufacturer.
6 Remove the lifting gear.
Fig. 17
1. Suspension points
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
CONNECTING THE LINES
Connect all the supply lines between the engine
and the aircraft.
The supply lines are connected and disconnec-
ted the same way. See also section 71-00-00
Removal
71-00-00
Page 21
July 01/2012