Rotax 912 i Series Maintenance Manual page 364

Fig. 32
1. Airbox
WIRING HARNESS REMOVAL
- The wiring harness can be removed.
INSPECTION
NOTICE
WARNUNG
When work is carried out on the components of
the engine management system, there is a risk
that these might get damaged.
Never put measuring probes in plug connectors
or use other "aids" to carry out tests in the plug
connectors.
NOTICE
WARNUNG
All electronic components must be in the ori-
ginal state.
Any modification e.g. to the wiring harness can
lead to incorrect inputs or operating faults.
- General visual inspection. See section 05-00-
00 and 12-20-00 in the corresponding Main-
tenance Manual Line for the 912 i Series
engine type.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. Cable ties
It must be ensured that all plug-in con-
NOTE:
nections are properly crimped with the
cables. (There must be no bent, defor-
med or loose pins in the plug connec-
tions!)
Electric test
The electric test of the wiring harness takes
place in the installed state.
Step
1 Unplug the wiring harness at the ECU and
connect adapter part no. 277012.
Fig. 33
1. Adapter
Procedure
76-50-00
Page 16
July 01/2012