Rotax 912 i Series Maintenance Manual page 397

Step
3 Use an SW 17 torque wrench (or similar
tool) to tighten the temperature sensors in
the inlet pipes. Tightening torque 25 Nm
(19 ft.lb.).
4 Plug the respective wiring harness con-
nector into the corresponding pressure or
temperature sensor.
See section 76-50-00.
5 Carefully push the connector (EGT) in to
the locking plate.
Fig. 32
1. Connector (EGT)
KNOCK SENSOR (KNOCK) - INSTALLATI-
ON
Step
1 Clean the end face of the knock sensor.
2 Screw the knock sensor hand-tight into
engine block.
3 Adjust the knock sensor, do not let it come
into contact with the intake manifold.
4 Tighten the knock sensor.
Tightening torque 20 Nm (176.96 in.lb.).
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Locking plate
Procedure
Fig. 33
1. Connector (KNOCK)
Step
5 Plug the respective wiring harness con-
nector into the knock sensor.
6 Carefully push the connector (KNOCK) in
to the locking plate.
Fig. 34
1. Connector (KNOCK)
Step
7 Attach the cables of the knock sensor with
2 cable ties.
2. Locking plate
Procedure
2. Locking plate
Procedure
76-70-00
Page 27
July 01/2012