Rotax 912 i Series Maintenance Manual page 365

INSTALLATION
WIRING HARNESS - INSTALLATION
Preparation
- Check all the wiring harness sections provi-
ded.
WARNUNG WARNING
Non-compliance can result in serious injuries or
death!
The wiring harness must not be routed through
areas or fastened to components in which the
maximum permissible temperature of 120 °C
can be exceeded during engine operation.
NOTICE
WARNUNG
The plug connection of the ECU must be open-
ed and closed no more than 20 times!
This must be shown on the device by a clearly
visible sealing with a stamped numerical se-
quence (1-20) and by documentation confor-
ming to self-monitoring guidelines.
NOTICE
WARNUNG
Danger due to damage to the wiring harness!
For correct operation of the engine, it is
necessary for the wiring harness to be in full
working order and protected from scuffing,
wear, tearing, extreme bending radii and other
types of stress.
Do not route the wiring harness in the vicinity of
belt drives or rollers without the use of appropri-
ate protective measures.
Before connecting a connector, remove
NOTE:
the protective covering which may be at-
tached both to the connector and to the
connection socket.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
If necessary, clean the pins of the con-
NOTE:
nector and coat them as follows:
AMP/ECU connector with a thin layer of
Deoxit contact spray.
All the other connectors with a dielectric
silicone-based lubricant or an equivalent
lubricant.
Step
1
Fig. 34
1. Wiring harness
3. FUSE BOX
Procedure
Lay the wiring harness correctly
according to the routing plan.
2. ECU connection socket
4. Engine
76-50-00
Page 17
July 01/2012