Rotax 912 i Series Maintenance Manual page 64

ASSEMBLY
IGNITION HOUSING - ASSEMBLY
Whenever the ignition housing is in-
NOTE:
stalled or assembled, new, acid-free
greased o-rings and other sealing ele-
ments must always be used correctly!
Step
1 Polish and then clean the contact surface
for the oil seal.
OIL SEAL - INSTALLATION
Fig. 24
1. Contact surface
Step
2 Place new oil seal on insertion jig part no.
876020 and lubricate. Outer: LOCTITE
5910. Inner: KLUEBER ISOFLEX TO-
PAS.
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Fig. 25
1. Outer oil seal
3. Insertion jig part no. 876020
Step
3 Using a soft-faced hammer, tap the oil
seal with the insertion jig to press it in to
the ignition housing as far as it will go.
Fig. 26
1. Oil seal positioned
STATOR ASSY. - INSTALLATION
Step
1 Thread in the cable and then secure M4x8
adjustment screw with LOCTITE 243 and
tighten them.
2. Inner oil seal
Procedure
2. Insertion jig
Procedure
24-20-00
Page 14
October 01/2013