Rotax 912 i Series Maintenance Manual page 326

SITUATION 2:
EXTRACTING LOGS FROM AN IN-
STALLED ECU (ON AIRCRAFT)
NOTICE
WARNUNG
The battery must provide constant voltage thru
the whole extraction process. If this can't be en-
sured, an external power supply must be used.
Fig. 15
If the maintenance interfaces of
NOTE:
LANE A and LANE B are not conduct-
ed separately, the B.U.D.S. Aircraft
Set Sub-D DE9 connector can be
linked to the maintenance interface
directly.
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
4
1. Computer 2. B.U.D.S. Aircraft Set
3. Y-cablel 4. Cockpit (Simulation)
Connect Computer with ECU
Step
1 Connect B.U.D.S. Aircraft Set with the
USB-Port of your computer.
If the device is connected and installed
the RED indicator light should light up.
2 Connect the B.U.D.S. Aircraft Set Sub-D
DE9 connector with the Sub-D DE9 sock-
et of the Y-cable.
3 Connect both Sub-D DE9 sockets of the
Maintenance CAN with the Sub-D DE9
connectors of the Y-cable.
4 Now the setup should be as shown in
Fig. 15.
3
In case of using an USB extension ca-
NOTE:
ble, the length should not exceed
2 meters.
Procedure
1
2
09959
76-10-00
Page 14
October 01/2013