Rotax 912 i Series Maintenance Manual page 349

Introduction
This section describes the system, the removal, installation and inspec-
tion of the wiring harness assembly of the ROTAX 912 i Series engine.
The description is divided into sub-sections and explanations of system
functions.
1. Introduction
2. Special tools
3. Service products
4. System description
5. Safety information
6. Removal
7. Inspection
8. Installation
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Chapter: 76-50-00
WIRING HARNESS (MAIN STRAND)
Subject
A. Preparation
B. Wiring harness removal
(1) Starter relay - disconnection
(2) Ambient pressure sensor - disconnection
(3) Fuse box (FUSE BOX) - disconnection
(4) Fuel pump - disconnection
(5) Control unit (ECU) - disconnection
(6) EGT connector and ignition coil - disconnection
(7) Temperature sensor CTS - disconnection
(8) Injector - disconnection
(9) Throttle potentiometer - disconnection
(10) Temperature sensor (oil) and pressure sensor
(oil) - disconnection
(11) Crankshaft position sensor - disconnection
(12) Knock sensor - disconnection
(13) Airbox pressure sensor and temperature sensor -
disconnection
A. Electric test
A. Preparation
B. Wiring harness - installation
(1) Airbox pressure sensor and temperature sensor -
connection
(2) Knock sensor - connection
(3) Crankshaft position sensor - connection
(4) Temperature sensor (oil) and pressure sensor (oil)
- connection
(5) Throttle potentiometer - connection
(6) Temperature sensor (CTS) and injectors
(7) Strain relief - connection
(8) Control unit (ECU) - connection
Page
Page 1
Page 3
Page 3
Page 6
Page 6
Page 6
Page 6
Page 6
Page 6
Page 7
Page 7
Page 8
Page 9
Page 10
Page 12
Page 12
Page 13
Page 14
Page 14
Page 15
Page 15
Page 16
Page 16
Page 17
Page 17
Page 17
Page 19
Page 19
Page 19
Page 19
Page 19
Page 19
Page 21
Page 22
76-50-00
Page 1
July 01/2012