Rotax 912 i Series Maintenance Manual page 102

ROLLER BEARING VERSION 3 -
REMOVAL
Preparation
- The propeller gearbox must be removed so
that the roller bearing can be removed.
See section 72-10-00.
- Remove the governor flange.
NOTICE
WARNUNG
The pressing out process for version 3 with the
hydraulic governor is different from that for ver-
sions 2 and 4. The roller bearing is pressed out
together with the oil inlet flange.
See to .
Fig. 7 Fig. 8
Step
1 Remove the retaining ring with the circlip
pliers.
2 Put on puller part no. 876489 and push
the hex. screw through the cap, roller
bearing and oil inlet flange.
Fig. 7
1. Retaining ring
Step
3 Install the washer and nut on the rear.
4 The roller bearing is pressed out together
with the oil inlet flange by turning the hex.
screw clockwise.
5 Remove the O-rings.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Procedure
Fig. 8
1. Puller part no. 876489
3. Washer
5. Roller bearing
7. O-rings
2. Hex. screw
4. Hex. nut
6. Oil inlet flange
61-20-00
Page 8
July 01/2012