Rotax 912 i Series Maintenance Manual page 107

Fig. 19
1. 52x2 retaining ring
Step
4 Place on the vacuum pump gear and fix
the lubricated drive sleeve with the retain-
ing tool part no. 242660.
5 Secure M8x16 Allen screw with LOCTITE
648 and tighten it.
Tightening torque 25 Nm (221.2 in. lb.)
Fig. 20
1. Retaining tool part no.
242660
3. M8x16 Allen screw
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Drive sleeve
4. Vacuum pump gear
GOVERNOR FLANGE - INSTALLATION
Step
1 Install the governor flange including the
distance sleeve in the crankcase with a
new 32x4 O-ring.
2 Place one 7x2 O-ring each in the flange
(oil feed line) and governor flange and
hold them in position with a little grease.
Fig. 21
1. Distance sleeve
3. 7x2 O-ring
Step
3 Place on the governor flange, secure it
using LOCTITE 243 with 4 M6x20 Allen
screws on the crankcase and with 2
M6x16 Allen screws on the flange (oil
feed line), and tighten the screws.
Tightening torque 10 Nm (88.48 in. lb.).
NOTICE
WARNUNG
Longer screws destroy the oil feed line flange.
Procedure
2. 32x4 O-ring
Procedure
61-20-00
Page 13
July 01/2012