Rotax 912 i Series Maintenance Manual page 59

Step
3 Prise back the retaining tab and at the
same time carefully pull on the line until
the terminal is detached.
Fig. 11
1. Retaining tab
Step
4 Pull off the rubber seal.
Fig. 12
1. Cable
3. Filler plug
Step
5 Remove cable clamps.
6 Unscrew lock nut and remove the washer,
disk springs and distance sleeve.
7 Remove the adjustment screw and lead-
through seal.
Note the location of the cable clamps for
NOTE:
reassembly!
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Screwdriver
Procedure
2. Rubber seal
Procedure
Fig. 13
1. M6x16 Allen screw
Fig. 14
1. Distance sleeve
3. Washer 5.1/15.5/2.5
2. Cable clamp 8/M6
2. Disk springs
4. Lock nut M5
24-20-00
Page 9
October 01/2013