Rotax 912 i Series Maintenance Manual page 67

INSTALLATION
FLY WHEEL ASSY. - INSTALLATION
Preparation
Clean all flat surfaces
NOTE:
Step
1 Lubricate the flat surface of the sprag
clutch housing with LOCTITE 648.
2 Place fly wheel on top.
3 Secure 6 M6x12 Allen screws (12.9 screw
strength) with LOCTITE 603 and tighten
them. Tightening torque 18 Nm (159.3
in. lb.).
Fig. 33
1. Fly wheel
IGNITION HOUSING ASSY. -
INSTALLATION
Preparation
- Check whether dowel pins have been inser-
ted
Fig. 34
1. Dowel pins
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. M6x12 Allen screw
Step
1 Lubricate oil seal, bearing bushing and
crankshaft stub with KLUEBER ISOFLEX
TOPAS Nb5051.
2 Insert 5x2 O-ring into the crankcase and
lubricate with KLUEBER ISOFLEX TO-
PAS Nb5051 to hold in position.
Fig. 35
1. Oil seal
3. Crankshaft stub
Fig. 36
1. Crankcase
Step
3 Install puller assy. part no. 876010 on ig-
nition housing. Lubricate the sealing sur-
face of the ignition housing with LOCTITE
5910.
Procedure
2. Bearing bushing
2. O-ring 5x2
Procedure
24-20-00
Page 17
October 01/2013