Rotax 912 i Series Maintenance Manual page 288

Step
4 Plug the ignition coil connector into the
double ignition coils and press the EGT
connector into the plug holder.
NOTE: Check for secure connection.
Fig. 19
1. Ignition coil connector
3. EGT connector
NOTICE
WARNUNG
The Allen screws for the spring type hose clips
go into the intake duct, they are therefore glued
in with LOCTITE 243.
Leaking Allen screws can cause an excessively
lean mixture!
Step
5 Secure the 12/M6 cable clamp with an
M6x14 Allen screw and washer with LOC-
TITE 243.
Tightening torque 10 Nm (88.48 in. lb.).
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Double ignition coils
Procedure
Fig. 20
1. M6x14 Allen screw
3. 12/M6 cable clamp
INTERNAL GENERATOR - INSTALLATION
See also section 24-20-00 Internal generator.
FINISHING WORK
- Carry out an engine test run. See also section
12-20-00 Planned maintenance and
section 70-00-00 Standard work on the
engine.
2. A6 lock washer
74-20-00
Page 16
July 01/2012