Rotax 912 i Series Maintenance Manual page 334

The currently installed ECU Software
NOTE:
version ("Software P/N"/section "
ECU Configuration Data") and the set
Engine Type (section "User Configu-
rable Parameters") can be seen in the
"Connection" Tab. The last three dig-
its of the "Software P/N" illustrate the
currently installed ECU Software ver-
sion.
WARNUNG WARNING
Only Software that suits to a specific engine type
is allowed to be flashed on an ECU (see
SB-912 i-002iS). If the Engine Type in the ECU
deviates from the hardware configuaration of
the engine, contact a ROTAX Distributor
immediately.
Fig. 27
B.U.D.S. Aircraft "Connection"
Step
9 Switch to "Software Load"-Tab.
10 Select "Browse" in the Software Package
Loading section.
11 Navigate to the appropriate ECU Soft-
ware file (.ath) and confirm with "Open".
12 The path to this file and the Software P/N
will be shown in the "Software Package
Loading" section.
Effectivity: 912 i Series
Edition 1/Rev. 1
BRP-Powertrain
MAINTENANCE MANUAL
09967
Procedure
Fig. 28
B.U.D.S. Aircraft "Maintenance Mode" : Software Load
Step
13 Select "Load Package".
14 Consequently a window will open to en-
sure that the user is aware of flashing the
ECU Software. Confirm this window with
"OK".
15 Please wait until the Software flashing
process is finished. The process itself
should take approximately 1 minute (a
status display will indicate the progress).
16 After the Software flashing process has
finished, the "Connection"-Tab will be
shown. Check if the Software P/N equals
the Software version which was intended
to be installed.
09966
Procedure
76-10-00
Page 22
October 01/2013