Rotax 912 i Series Maintenance Manual page 297

Fig. 8
1. Water pump housing
3. M6x35 Allen screw
(stainless steel)
5. 6x10 DIN 7603 gasket
ring
Step
4 Remove the impeller anti-clockwise with
the special tool part no. 877295 with the
crankshaft immobilised.
NOTE: To immobilise the crankshaft,
see section 12-20-00 in the
Maintenance Manual Line.
Fig. 9
1. Impeller
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. M6x35 Allen screw
4. 6.4 washer
6. M6x90 Allen screw
Procedure
2. 8.2/12.5/1.5 washer
DISASSEMBLY
IGNITION HOUSING - DISASSEMBLY
Preparation
- Remove the ignition housing. See also sec-
tion 24-20-00 Internal generator.
WATER PUMP SHAFT - REMOVAL
Step
1 Place the ignition cover on a suitable flat
surface.
2 Press out the water pump shaft with a
suitable tool.
3 Pull out the water pump gear.
Fig. 10
1. Press-out tool
3. Water pump shaft
OIL SEAL AND ROTARY SEAL -
REMOVAL
NOTICE
WARNUNG
The oil seal and rotary seal are destroyed by this
process and must be replaced.
Step
1 Press out the old oil seal and the rotary
seal with two bolts and a suitable jig.
NOTE:
The diameter of the bolt is 5 mm
(0.1969 in.).
Procedure
2. Water pump gear 15T
Procedure
75-00-00
Page 9
July 01/2012