Rotax 912 i Series Maintenance Manual page 398

Fig. 35
1. Cable ties
FINISHING WORK ON THE KNOCK SEN-
SOR
Follow the same procedure as removal when
doing this work. See section 76-70-00 Knock
sensor removal – preparation
CRANKSHAFT POSITION SENSOR ASSY.
(CPS_1/CPS_2) - INSTALLATION
NOTICE
WARNUNG
Ensure that the O-ring rests on the sensor.
Step
1 Push the cable clamp onto the cable.
NOTICE
WARNUNG
Arrange the cable so that it does not rest against
the engine suspension frame or other compo-
nents.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
Fig. 36
1. Crankshaft position
sensor CPS_1
3. M6x20 allen screw
5. Cable clamp
Step
2 Secure M6x20 Allen screw with LOCTITE
243 and tighten it.
Tightening torque 10 Nm (88.48 in. lb.).
3 Plug the respective wiring harness con-
nector into the crankshaft position sensor.
4 Carefully push the connector (CPS) into
the locking plate.
Fig. 37
1. Connector (CPS)
2. Crankshaft position
sensor CPS_2
4. Washer
6. O-ring
Procedure
2. Locking plate
76-70-00
Page 28
July 01/2012