Rotax 912 i Series Maintenance Manual page 382

- Open the 1-ear clamp on the intake manifold
1/3.
- Remove the intake manifold 1/3 assy. with
the fuel rail and put it to one side. See also
section 73-10-00 Fuel system.
The assemblies and lines are only to be
NOTE:
removed if necessary and only as far as
is necessary!
Installation position: Cylinder head 1
See Fig. 13.
Step
1 Unplug the connector of the wiring har-
ness from the knock sensor. See also
section 76-50-00 Wiring harness (main
strand).
2 Lift the latch and pull apart.
3 Pull the connector out of the support
plate.
Fig. 13
1. Connector
Step
4 Cut open the cable ties.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Procedure
2. Support plate
Procedure
Fig. 14
1. Cable ties
NOTICE
WARNUNG
Mark the position of the sensor!
Step
5 Loosen the M8x30 hex. screw.
6 Remove the knock sensor.
Fig. 15
1. Knock sensor
Procedure
2. Hex. screw
76-70-00
Page 12
July 01/2012