Rotax 912 i Series Maintenance Manual page 367

Pos. Part no. of connector set
6 881306
7 881308
8 881302
9 881304
10 881294
11 881312
12 881310
AIRBOX PRESSURE SENSOR AND TEM-
PERATURE SENSOR - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
KNOCK SENSOR - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
CRANKSHAFT POSITION SENSOR - CON-
NECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
Note:
- CPS_1 for LANE A (upper crankshaft position
sensor)
- CPS_2 for LANE B (lower crankshaft position
sensor)
The sensors are identical, they are not
NOTE:
labelled.
TEMPERATURE AND PRESSURE SEN-
SOR (OIL) - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
THROTTLE POTENTIOMETER - CONNEC-
TION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Crimping pliers TYCO 539 635-1
Jaws TYCO 539 737-2
Disassembly tool DELPHI 12094429
Crimping pliers DELPHI 12155975
Disassembly tool DELPHI 12094429
Crimping pliers MOLEX 0638114400
Disassembly tool MOLEX 63813-1500
Crimping pliers TYCO 58495-1'
Disassembly tool TYCO 305 183
Crimping pliers TYCO 180319
TEMPERATURE SENSOR CTS AND IN-
JECTOR - CONNECTION
The sensors are connected and disconnected in
the same way. See section 76-50-00 Removal.
Note:
WARNUNG
Do not clamp the cables for INJ_4 and CTS
(Coolant Temperature Sensor) together.
Step
1
2
Fig. 35
1. Temperature sensor CTS 2. INJ_4
Corresponding tool
NOTICE
Procedure
Screw on the cable clamp finger-tight with
an M6x14 screw and 6.4 washer.
Plug in the temperature sensor with the
CTS cable.
76-50-00
Page 19
July 01/2012