Rotax 912 i Series Maintenance Manual page 409

SYSTEM DESCRIPTION
The exhaust collects the gases produced in the
combustion chamber, leads them via the
exhaust manifold to the muffler, which is used to
reduce noise. The exhaust gas passes via the
outflow pipe through a tail pipe into the open.
MAINTENANCE
As well as the maintenance and special checks,
see the relevant Maintenance Manual Line for
the respective 912 i Series engine type.
REMOVAL
EXHAUST ASSY. - REMOVAL
WARNUNG WARNING
Danger of severe burns and scalds! Allow the
engine and exhaust to cool to ambient tem-
perature before starting work.
NOTICE
WARNUNG
Follow the aircraft manufacturer's instructions
for removal.
Preparation
See also section 76-50-00 Wiring harness.
- Unplug the temperature sensor (EGT).
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Fig. 1
1. Exhaust flange
3. Exhaust pipe
EXHAUST PIPE - REMOVAL
Step
1
Fig. 2
1. M8 hex. nut
3. Exhaust pipe
2. Temperature sensor (EGT)
Procedure
Loosen 2 M8 hex. nuts.
NOTE: This is a lock nut!
2. Cylinder head
4. Exhaust flange
78-10-00
Page 5
July 01/2012