Rotax 912 i Series Maintenance Manual page 90

Fig. 9
1. M5x12 countersunk
screw
OIL SEAL - INSTALLATION
Step
1 Press in a new oil seal with insertion jig
part no. 877276 and lubricate with engine
oil.
Fig. 10
1. Insertion jig part no. 877276
VACUUM PUMP GEAR - INSTALLATION
Step
1 Place on the vacuum pump gear and fix
the lubricated drive sleeve with the
retaining tool part no. 242660.
2 Secure M8x16 Allen screw with LOCTITE
648 and tighten it.
Tightening torque 25 Nm (18.44 ft.lb.)
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. Retaining washer
Procedure
2. Oil seal
Procedure
Fig. 11
1. Retaining tool part no. 242660 2. Drive sleeve
3. M8x16 Allen screw
VACUUM PUMP - INSTALLATION
Step
1 Check that the studs are firmly in place. If
necessary, apply LOCTITE 243 and
tighten.
Tightening torque 5 Nm (44.25 in.lb.).
Fig. 12
1. M6 studs
4. Vacuum pump gear
Procedure
37-10-00
Page 8
July 01/2012