Introduction
This section describes the maintenance of the internal generator assembly of
the ROTAX 912 i Series engine. The description is divided into sub-sections
and explanations of system functions.
1. Introduction
2. Special tools
3. Service products
4. System description
5. Safety information
6. Removal
7. Inspection
8. Wear limits
9. Assembly
10. Installation
11. Finishing work
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
Chapter: 24-20-00
INTERNAL GENERATOR
Subject
A. Preparation
B. Ignition housing - removal
C. Fly wheel assy. - removal
D. Stator assy. - removal
A. Ignition housing single parts check
(1) Ignition housing - check
(2) Bearing bushing - check
(3) Oil seal replacement
(4) Stator assy. - inspection
A. Ignition housing - assembly
(1) Oil seal - installation
(2) Stator assy. - installation
(3) Controller connector - assembly
A. Fly wheel - installation
B. Ignition housing assy. - installation
Page
Seite 1
Seite 3
Seite 3
Seite 5
Seite 5
Seite 6
Seite 6
Seite 6
Seite 8
Seite 8
Seite 11
Seite 11
Seite 11
Seite 11
Seite 12
Seite 12
Seite 13
Seite 14
Seite 14
Seite 14
Seite 14
Seite 15
Seite 17
Seite 17
Seite 17
Seite 19
24-20-00
Page 1
July 01/2012