Rotax 912 i Series Maintenance Manual page 264

Fig. 69
1. M5x35 Allen screw
3. Heat shield
Step
2 Install the M12x1.5x24 banjo bolt with two
A12x18 gasket rings.
Tightening torque 25 Nm (221.2 in. lb.).
Fig. 70
1. M12x1.5x24 banjo bolt
3. Fuel pressure regulator
assy.
Step
3 Fix hose 60 (regulator/airbox) with
2 cable ties.
4 Plug in temperature sensor CTS.
Effectivity: 912 i Series
Edition 1/Rev. 0
BRP-Powertrain
MAINTENANCE MANUAL
2. M5x45 Allen screw
Procedure
2. A12x18 gasket rings
Procedure
Fig. 71
1. 94x2.5mm cable ties
3. Temperature sensor CTS
THROTTLE BODY ASSY. -
INSTALLATION
NOTE: When the throttle body is installed, a new
rubber gasket ring must be used!
Step
1 Install the rubber gasket ring.
NOTE: The rubber gasket ring is ins-
talled dry!
Fig. 72
1. Throttle body assy.
2. 60 +/-3mm hose
Procedure
2. Rubber gasket ring
73-10-00
Page 32
July 01/2012