Example
This example shows how to display the switch's boot firmware image:
D2(su)->show boot system
Current system image to boot: bootfile
set boot system
Use this command to set the firmware image the switch loads at startup.
Syntax
set boot system filename
Parameters
filename
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the boot firmware image file to "newimage":
D2(su)->set boot system newimage
Starting and Configuring Telnet
Purpose
To enable or disable Telnet, and to start a Telnet session to a remote host. The D‐Series switch
allows a total of four inbound and / or outbound Telnet session to run simultaneously.
Commands
The commands used to enable, start and configure Telnet are listed below.
For information about...
show telnet
set telnet
telnet
Specifies the name of the firmware image file.
set boot system
Refer to page...
2-38
2-38
2-39
D-Series CLI Reference 2-37