Configuring T1/E1 and T3/E3 Subsystems
Observing Syntax and Conventions
The CLI Syntax and conventions use the notation described in the following table.
Convention
xyz
[x]
[x | y | z]
{x | y | z}
[x {y | z} ]
(config-if<xx>)
Next Mode entries display the CLI prompt after a command is entered
soho.enterasys.com
T1/E1 & T3/E3 Commands
The following commands define T1/E1 /T3/E3 subsystem functionality:
•
"T1/E1 & T3/E3 Commands" on page 2‐55.
•
"T1/E1 and T3/E3 Clear and Show Commands" on page 2‐74.
•
"Drop and Insert Commands" on page 2‐80.
Description
Key word or mandatory parameters (bold)
[ ] Square brackets indicate an optional parameter (italic)
[ | ] Square brackets with vertical bar indicate a choice of values
{ | } Braces with vertical bar indicate a choice of a required value
[{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
xx signifies interface type and number, e.g.: F1, S2/1.0, D1, M57, G3. F
indicates a FastEthernet, and G a GigabitEthernet interface
Italicized, non-syntactic text indicates either a user-specified entry or text
with special emphasis
Note: The configuration commands for T1/E1 ports that occupy T3/E3 lines are the same
commands that exist for T1/E1 NIM cards.
2
XSR CLI Reference Guide 2-55