Power-Up Reboot; Reload Command From The Cli; Bootrom Monitor Commands Bc And Bw; Watchdog Timer Expiration - Enterasys X-Pedition XSR-3020 Getting Started Manual

XSR Rebooting Characteristics
Table 1 Reboot Triggers (continued)
Cause
SNMP reload
Watchdog Expiration
Software Crash
Repetitive Software Crash
ROM Monitor
Invalid SW text checksum

Power-Up Reboot

If you power cycle the XSR by flipping the switch on the back panel, the XSR will cold reboot. The
startup-config

Reload Command from the CLI

You can reboot the XSR firmware by issuing the command
prompted to confirm the command. Once the firmware is reloaded, the configuration is loaded
from the startup-config file.

Bootrom Monitor Commands bc and bw

Using Bootrom Monitor mode, you can activate warm or cold reboots by entering
respectively. Refer to

Watchdog Timer Expiration

When the internal watchdog timer expires, causing the XSR to fail, fault information is captured in
a report and a warm boot is initiated. But if more than three warm boots are detected within one
minute, a cold boot will be initiated.

System Crash

When system exceptions occur causing the XSR to fail, fault information is captured in a report
and a warm boot is initiated. But if more than three warm boots are detected within one minute, a
cold boot will be initiated.

Restart with Default Configuration Interrupt

When you press the Default button on the back panel, the XSR restarts using factory default
parameters, ignoring the

Power-up Error Conditions

After power-up, the XSR comes up automatically if:
• The minimum hardware is functional: Processor, RAM and FLASH memory, and other
components.
3-34 Software Configuration
Boot Type
Cold or Warm
Warm
Warm
Cold
Cold or Warm
Warm
file stored in Flash becomes the running configuration.
"Bootrom Monitor Mode Commands"
startup-config
reload <cold | warm>
on page 3-35 for more data.
file.
. You are then
bw bc
or ,