Clear Radius Accounting; Configuring 802.1X Authentication; Purpose; Commands - Enterasys D2 D2G124-12P Cli Reference Manual

clear radius accounting

Use this command to clear RADIUS accounting configuration settings.
Syntax
clear radius accounting {server ip-address | retries | timeout | counter}
Parameters
server ip‐address
retries
timeout
counter
Mode
Switch command, read‐write.
Defaults
None.
Example
This example shows how to reset the RADIUS accounting timeout to 5 seconds.
D2(su)->clear radius accounting timeout

Configuring 802.1X Authentication

Purpose

To review and configure 802.1X authentication for one or more ports using EAPOL (Extensible
Authentication Protocol). 802.1X controls network access by enforcing user authorization on
selected ports, which results in allowing or denying network access according to RADIUS server
configuration.

Commands

For information about...
show dot1x
show dot1x auth-config
set dot1x
set dot1x auth-config
clear dot1x auth-config
Clears the configuration on one or more accounting servers.
Resets the retries to the default value of 3.
Resets the timeout to 5 seconds.
Clears counters.
Note: To configure EAP pass-through, which allows client authentication packets to be forwarded
through the switch to an upstream device, 802.1X authentication must be globally disabled with the
set dot1x command ("set dot1x" on page 15-13).
clear radius accounting
Refer to page...
15-10
15-11
15-13
15-14
15-15
D-Series CLI Reference 15-9