Ip Ospf Cost - Enterasys X-Pedition XSR CLI Cli Reference Manual

OSPF Commands

ip ospf cost

This command sets the cost of sending a packet on a interface. Each router interface that
participates in OSPF routing is assigned a default cost. This command overwrites the default.
Syntax
ip ospf cost cost
cost
Syntax of the "no" Form
no ip ospf cost
Mode
Interface configuration:
Default
10
Example
The following example sets cost 20 for interface FastEthernet 1:
XSR(config)#interface fastethernet 1
XSR(config-if<F1>)#ip ospf cost 20
ip ospf dead-interval
This command sets the interval a router must wait to receive a hello packet from its neighbor
before determining that the neighbor is out of service.
Syntax
ip ospf dead-interval seconds
seconds
Syntax of the "no" Form
The no form of this command sets the value to the default:
no ip ospf dead-interval
Mode
Interface configuration:
5-94 Configuring the Internet Protocol
Cost of sending a packet ranging from 1 to 65,535.
XSR(config-if<xx>)#
Interval that a router must wait to receive the hello packet. It must be the same
on neighboring routers (on a specific subnet), but it can vary between subnets.
This value is an unsigned integer ranging from 1 to 65,535 seconds.
XSR(config-if<xx>)#