Setting Up Rip Routing - Enterasys X-Pedition XSR-3150 Getting Started Manual
Security router
Hide thumbs
Also See for X-Pedition XSR-3150:
- Datasheet (6 pages) ,
- Getting started manual (110 pages) ,
- Quick reference card (2 pages)
Table of Contents
Advertisement
Setting Up RIP Routing
XSR(config)#ip firewall filter allowICMP private dmz protocol-id 1
XSR(config)#ip firewall filter allowICMP private ANY_EXTERNAL protocol-id 1
XSR(config)#ip firewall filter allowICMP ANY_EXTERNAL dmz protocol-id 1
Trial load the completed configuration into the firewall engine, and if successful, load the
configuration:
XSR(config)#ip firewall load trial
XSR(config)#ip firewall load
Complete LAN and WAN interface configuration:
XSR(config)#interface gigabitethernet 1
XSR(config-if<F1>)#ip address 220.150.2.35/24
XSR(config-if<F1>)#no shutdown
XSR(config)#interface gigabitethernet 2
XSR(config-if<F2>)#ip address 220.150.2.17/24
XSR(config-if<F2>)#no shutdown
XSR(config)#interface serial 1/0:0
XSR(config-if<S1/0:0>)#ip address 206.12.44.16/24
XSR(config-if<S1/0:0>)#no shutdown
Globally enable the firewall. Even though you have configured and loaded the firewall, only
invoking the following command "turns on" the firewall. Once enabled, if you are remotely
connected, the firewall will close your session. Simply login again.
XSR(config)#ip firewall enable
For more Firewall configuration examples, refer to the XSR User's Guide.
Setting Up RIP Routing
The following commands configure a GigabitEthernet and Serial interface to support RIP with
additional functionality as an option:
1.
Enter interface gigabitethernet <1 | 2 | 3> to acquire Interface mode and select one of the
GigabitEthernet ports.
2.
Enter ip address <xxx.xxx.xxx.xxx> <yyy.yyy.yyy.yyy> where x is the IP address and y is the
subnet mask of this GigabitEthernet port.
3.
Enter no shutdown to keep the interface enabled.
4.
Enter interface serial <slot # | card # | port #> of the serial NIM card to re-acquire Interface
mode and select slot, card and port numbers.
5.
Enter ip address <xxx.xxx.xxx.xxx> <yyy.yyy.yyy.yyy> where x is the IP address and y is the
subnet mask of the serial port.
6.
Enter ip rip authentication mode text if you want to set clear-text authentication. If you enter
this command, continue with the
7.
Enter ip rip authentication key-string <text> to specify a text string for authentication.
8.
Enter no shutdown to keep the interface enabled.
9.
Enter ip rip send version <1 | 2> to allow the RIP version of update transmissions. Version 1
is the default value.
3-14 Software Configuration
Step
7, otherwise, go to
Step
8.
Advertisement
Table of Contents
