Table of Contents
Advertisement
Mode
Global configuration:
Examples
The following example selects a 5‐minute auto install:
XSR(config)#netload
The following example selects a persistent auto install:
XSR(config)#netload persistent
SNTP Commands
sntp-client
This command enables the SNTP client and sets the Simple Network Time Protocol (SNTP)
primary and alternate server IP addresses. Once the XSR is configured, it sends a time request to
the SNTP server every poll interval to update local time.
Syntax
sntp-client server A.B.C.D [A.B.C.D]
A.B.C.D
[A.B.C.D
Syntax of the "no" Form
The no form of this command disables the SNTP client:
no sntp-client
Mode
Global configuration:
Defaults
•
Primary and alternate server IP address: 0.0.0.0
•
SNTP client is disabled
Example
The following example sets the primary SNTP server IP address:
XSR(config)#sntp-client server 192.168.27.88
XSR(config)#
Note: Setting the SNTP Server IP address to 0.0.0.0 disables the SNTP client.
IP address of the primary SNTP server.
IP of the alternate SNTP server. Set only if the primary SNTP server IP is set.
XSR(config)#
SNTP Commands
XSR CLI Reference Guide 3-91
Advertisement
Table of Contents
