Remove; Rename - Enterasys X-Pedition XSR-1850 Getting Started Manual

remove

This command removes a file using the syntax

rename

This command renames a file using the syntax
sb
This command displays boot values. Sample output is shown as follows:
XSR-1800: sb
Current boot file is xsr1800.fls
Boot selector default is flashrom, compactFlash, network
Available Network boot devices:
sf
This command shows a fault report. Sample output is shown as follows:
XSR-1800: sf
No fault report at 0x1feef00
si
This command displays system inventory. Sample output is shown as follows:
XSR-1800: si
IBM PowerPC 405GP Rev. D
Processor speed
PLB speed
OPB speed
Ext Bus speed
PCI Bus speed
Internal PCI arbiter enabled
RAM installed: 32MB
Flash installed: 8MB on processor board
CompactFlash: SunDisk SDP 5/3 0.6 has 32047104 bytes
Real Time Clock
FastEthernet 1
FastEthernet 2 Rev 0
H/W Encryption Accelerator Rev 1
T1E1 has 4 channelized ports on NIM slot 1. Rev 0
ISDN BRI has 2 ST ports in NIM slot 2. Rev 1
Empty internal NIM slot 3
System up for 345 seconds.
Eth1
= 200 MHz
= 100 MHz
= 33 MHz
= 25 MHz
= 33 MHz (Sync)
remove <source name> <destination name>
rename <source name> <destination name>
Bootrom Monitor Mode Commands
XSR Getting Started Guide 3-41